My PLC does not give me an IP inside my local network

0

You see, I know that this question has no relation with any programming language but it is a problem of networks and I know that here there has to be someone who can guide me.

The fact is that a few months ago I bought some PLC's to give internet to my desktop, since Wi-Fi practically did not arrive. I recently discovered that you can do something similar to Steam Link with a Raspberry Pi and a program called Moonlight. I had everything downloaded and installed on the Rasp and it was when I realized that my raspberry could not see my computer. Configure a static IP as well as the subnet mask and DNS but nothing, it was impossible for my computer (Windows 10) to see the Rasbperry.

When I had DHCP enabled, I could see that I was assigned a strange IP, and through link I realized that the IP that this page showed me was the same as my computer, when usually when you connect to that page from a computer via wifi (for example) the IP that shows you is the one of your router, but it was not the case here.

My question is, can I make that IP change and DHCP give me a correct address?

PS: my PLC's are: link

Thank you very much in advance

    
asked by Marcos Álvarez 14.06.2018 в 21:24
source

1 answer

0

First discard that the plc are wrong. Connect the raspberry directly to the router and check that it gives you a good ip. If so, the problem is the configuration of the plc. Reset and return to the beginning, try to update firmware.

    
answered by 25.06.2018 в 12:50